Instructions for use for polycarbonate casting molds
Cleaning and first use
• The molds must be washed before first use ◦ Do not mechanically clean the molds (hard objects) using cotton wool, soft brushes or sponges
NichtDo not hold the water jet at a pressure of <3 bar, reduce the water flow, if necessary
NachRinse with distilled water for osmosis prevention
◦Cleansing agents should not exceed the ph value of 12 and rinse aid of 7
◦Use a minimum dosage of the remedies
◦ Observe the recommendations of the detergent manufacturer
FormenThe molds should not be treated above 60 ° C during cleaning and drying
◦ Let the molds dry well
Article knocking
• When knocking the articles out, make sure that no big blows are made, several small beats are better than a big one.
Storage of the forms
• When storing, make sure that the molds are completely dry and stored without pressure.
• Store the molds dry and dark, protect against UV radiation (otherwise the material will yellow)
disposal
• The molds are made of grade polycarbonate and can be easily recycled
• if necessary, send back the washed molds.
We wish you a lot of fun with shapes
© by hbs24